Gender
Male
About
Location
Sydney
About Me:
An embedded software engineer
Please tell us a bit about your UAV interest
I am interested in this.
Hometown:
China
Activity Feed
"Hi Chris,
I am building the firmware for RFD 9000+ (i think it is RDF 900p as well). I downloaded the source code from branch :https://github.com/RFDesign/SiK/tree/SiK. And Compiling is OK. Then I uploaded the new firmware onto one of my two radio…"
I am building the firmware for RFD 9000+ (i think it is RDF 900p as well). I downloaded the source code from branch :https://github.com/RFDesign/SiK/tree/SiK. And Compiling is OK. Then I uploaded the new firmware onto one of my two radio…"
"Hi Chris,
Thank you for your advice. I use the 3DRRadio config for configuration. But I did not found the option to inject the MAVLink RSSI. Could you tell me which configuration tool you use?
Jason"
Thank you for your advice. I use the 3DRRadio config for configuration. But I did not found the option to inject the MAVLink RSSI. Could you tell me which configuration tool you use?
Jason"
"thank for your reply. Chris.
No, the MAVLink is not used. Do you mean that if MAVLink is used, RSSI value can be in MAVLink message?
I am a little confused. I'd like to get the RSSI from RS232 interface and show it on a display.
Could you please…"
No, the MAVLink is not used. Do you mean that if MAVLink is used, RSSI value can be in MAVLink message?
I am a little confused. I'd like to get the RSSI from RS232 interface and show it on a display.
Could you please…"
"Hi Seppo,
I am using two RFD 900+ for radio control.
I have question about how to get the RSSI value. As I know I can get the RSSI value by entering the AT command mode. but that will interrupt the communication. So currently I enable the RSSI…"
I am using two RFD 900+ for radio control.
I have question about how to get the RSSI value. As I know I can get the RSSI value by entering the AT command mode. but that will interrupt the communication. So currently I enable the RSSI…"
