Time in air displayed in muntes

Hi,

Is it possible to display the 'time in air' in minutes in stead of seconds?

thanks

Read more…

unwanted switch to land mode

Hi,

I was testing my quadcopter in loiter and stabilize mode and suddenly switched to land mode.

My failsafe settings are RTL but it happened when my battery still was more then 22 Volts and failsafe set to 20 volts

The copter landed and after that I co

Read more…

Autonomous precision landing, programmer needed

Hi,

Currently I am working on a project.

Building a ground station on which a drone should land within 20 cm of the T shaped target using the pixhawk optical flow camera and pixhawk controller. If possible even less the 20 cm.

After landing automaticall

Read more…

Bluetooth communication with arduino ground station PIXHAWK

Hi,

Is it possible with the bluetooth module for the pixhawk to communicate with a arduino based ground station ?

I need to send a few codes to the arduino.

from copter to ground station:

first code (binary or something) meaning landed, motors switched o

Read more…

expert pixhawk programmer wanted

Hi,

I am new here and working in a project.

I build drones usually using dji controllers. They are not open source an I need some extra features.

Now want to use pixhawk since it can be programmed and adapted to my needs.

I can analyze and make a flowcha

Read more…