Gender
Male
About
Location
Laredo, TX
Please tell us a bit about your UAV interest
A school project started my interest.
Hometown:
Laredo
Activity Feed
"It does this during manually 1 per 1 calibration. All motors would calibrate successfully, but when checking if they spin by moving the throttle, 3 motors spin normally for a few seconds then slowly die and stop. The 4th motor works as intended. …"
I'm currently using a 3 cell 5000mah LiPo batter. The battery connects to the 3DR Power Module, which connects to a wire harness power distribution. This PD connects to each of the ESCs which connect to the motors.This problem wasn't happening…
I read that an APM power module can accept up to 18 volts and read up to 90 amps.The battery I'm using is a LiPo 3-Cell Battery of 11.1 volts but 5000mah and 20-30C. Does this mean its a 100-amp battery? I tried connecting to the Power Module and my…
I am currently trying to add ultrasonic detection to my flight controller. To do this, I was told I needed an Arduino because APM doesn't have enough processing power to handle sonar and flight control. The way I understand it is that you connect…
I have an APM 2.6. I was told that I need to install version 3.2.1 of the firmware of Mission Planner into it so I did. The firmware downloaded successfully and I am able to connect with the COM port, however when I see the flight data, the readings…
