Jim Phelps's Discussions (4)

Sort by

IRIS+ Motor Bearings

Has anyone had issues with the bearings in the MN2213 motors? I had a crash from low altitude.  The props were beat up bu there appeared to be more damage than that.  So I replaced the chewed up props and tried to take off, but the IRIS+ would not ho

Read more…

Cannot intialize battey voltage monitor

I cannot get the APM to read the battery voltage.

APM2.5

Ardurover 2.49

Voltage tapped off of 2S battery with potentiometer (8.2volts in=3.0volts out)

Monitor type is set to voltage only

Sensor (none), 

I have tried changing the monitor point from A13, A0,

Read more…

No reverse, No neutral on throttle

When vehicle starts, it apparently thinks it is at half throttle.  There is no reverseThere is no neutral at half throttle. I have to pull the throttle all the way back to stop the vehicle.  I am using the center-loaded elevator stick for the thro

Read more…