Please tell us a bit about your UAV interest
KK Copter -> MultiWii -> APM Pixhak
About
Hometown:
GER
Activity Feed
"Hi Angelos,
yes, I had. The solution is quite simple, since there is no issue at all. I just looked for the wrong value.^^ The correct rssi-value does not show up under "rssi" but under the "rxrssi" variable."
yes, I had. The solution is quite simple, since there is no issue at all. I just looked for the wrong value.^^ The correct rssi-value does not show up under "rssi" but under the "rxrssi" variable."
"I changed the settings as recommended on the previous page of this topic. So it's 38400 Baud. But I had to set the protocol out to UBX + NMEA, because setting it to only UBX broke both USB and UART connection in u center. And after repowering the…"
"Hi,
is there anybody, who figured out how to solve the problem with the data stream glitches mentioned above at 5 Hz navigation rate? I'm setting up my Neo-M8N right now and also found the data stream not to be stable at 5 Hz, althoug the receiver…"
is there anybody, who figured out how to solve the problem with the data stream glitches mentioned above at 5 Hz navigation rate? I'm setting up my Neo-M8N right now and also found the data stream not to be stable at 5 Hz, althoug the receiver…"
Hi all,while looking for solutions for receiving multiple GNSS services, I stumpled across the new ublox M8 chipset and found several discussions about new GNSS receivers equiped with that chip, always stating these to be much better in accuracy and…
"GPS was 3D fix at the time, I did the test. ;) Although GPS precision and accuracy seem not be very good at the moment, but thats another story...
But I discovered another little issue with the failsafe especially with the battery failsafe. I…"
But I discovered another little issue with the failsafe especially with the battery failsafe. I…"
"Thanks a lot, Randy. I should have tested it in the air, but I wanted to ensure that everthing works properly before doing so."
"Okay, done."
"Thanks for your answer, Andre. And yes, the behaviour of the failsafe between stabilize and loiter is definitely different. When the copter is in stabilize and the TX being turned off the flight mode on the failsafe page changes from "stabilize" to…"
Hi guys,I'm using a Pixhawk with AC3.2-rc10 and ran into problems while setting up the throttle failsafe function. I followed the instructions on the wiki page and everything works fine and as described on that page while being in stabilize mode. So…
Hi guys,I'm using a Pixhawk with latest AC3.2-rc10 in combination with an FrSky X8R connected over SBUS and have been trying to get the rssi signal read from the receiver and monitoring it with Mission Planner for a while now, but I still can't get…
