Gender
Male
About
Location
Ottawa, Ontario
About Me:
Software Engineer at ING Robotic Aviation
Please tell us a bit about your UAV interest
Software Engineer at ING Robotic Aviation
Hometown:
Rockland
Activity Feed
"I have been using the PPM over RFD900x for a while.
I think that there are 8 channels passed through the RFD900x - I have not tried to put more through.
Here is a view of the signal coming out of the UAV end of the link.…"
I think that there are 8 channels passed through the RFD900x - I have not tried to put more through.
Here is a view of the signal coming out of the UAV end of the link.…"
"I have been using the RFD900x for a while - with V2.53 loaded.
Should I be installing V2.55?
What has changed (or where can I find out what has changed :) )
Very happy with how it is working so far.
Thanks
Michael"
Should I be installing V2.55?
What has changed (or where can I find out what has changed :) )
Very happy with how it is working so far.
Thanks
Michael"
"follow on about PPM use.
I have a system setup using the PPM over RFD900x to control a gimbal.
When the motor (electric heli) starts the gimbal usually rotates left and down. Looking at the PPM output from the radio it is outputting min on all…"
I have a system setup using the PPM over RFD900x to control a gimbal.
When the motor (electric heli) starts the gimbal usually rotates left and down. Looking at the PPM output from the radio it is outputting min on all…"
"Got it working (with a digital scope as target so far).
I used pin 15 on both ends of the link (Pin 2.6 in my documentation).
I did not have to use the AT Commands mentioned in the post
AT commands are:
1. for PPM input (ground)(pin 15 of header…"
I used pin 15 on both ends of the link (Pin 2.6 in my documentation).
I did not have to use the AT Commands mentioned in the post
AT commands are:
1. for PPM input (ground)(pin 15 of header…"
"We have purchased some 900x radios and I am looking for information on using the PPM passthrough mode.
Do I need to setup the Radio with AT commands or can it all be done inside of mission planner CIN and COUT check boxes...
i.e. setup Pins as…"
Do I need to setup the Radio with AT commands or can it all be done inside of mission planner CIN and COUT check boxes...
i.e. setup Pins as…"
