About

Gender

Male


Location

Christchurch


About Me:

I am a Mechanical Engineer interested in automation, mechanics, electronics and any combination of these.


Please tell us a bit about your UAV interest

Racing Drones and more recently UAV autonomous drones


Hometown:

Christchurch


Activity Feed

Patrick Yung replied to Alex's discussion Pixhawk / Dual UBEC Distribution Board VI ISSUE
"Yes, I am not an electronics engineer but I have tested the replaced 0.5ohm resistor with the 10k ohm resistor and at 10A I get a current voltage of about 0.3v. so assuming it is a linear correlation then at 100A it should not exceed around 3v. I…"
Sep 3, 2016
Patrick Yung replied to Alex's discussion Pixhawk / Dual UBEC Distribution Board VI ISSUE
"Hi Guys, I bought these 120A Ubecs aswell and had the same problems. The current sensors would not output a reading. I then bought some more cause I thought it was just a faulty one but it wasn't they are made/manufactured defective. But good news…"
Sep 2, 2016
Patrick Yung replied to Gustavo Guevara's discussion Radiolink Pixhawk PIX Flight Controller
"Hey There, I have one of these radiolink pixhawks and am having a small problem with it. I can not power it using battery/servo rail. It powers up fine via USB but does not boot when connected to battery. Wondering if it's a bad board or if I am…"
Aug 3, 2016