About

Gender

Male


Location

Bellingham, WA


About Me:

I am an embedded engineer of over 15 years, working on communications systems.


Please tell us a bit about your UAV interest

This is a new interest of mine to be able to test certain M2M possibilities with tracking.


Hometown:

Bellingham, WA


Activity Feed

Paul Hunt replied to Paul Hunt's discussion Internal Compass not showing up
"Well, after doing full resets of the board and simplifying it as much as possible, I still cannot get the board to detect the internal compass. So, without anything else to go on, I have to assume that its possible that the mag chip itself has…"
Aug 7, 2015
Paul Hunt replied to Paul Hunt's discussion Internal Compass not showing up
"I have tried downgrading firmware with no luck.

Has anyone heard of the magnetometer chip going bad on a Pixhawk itself?"
Aug 6, 2015
Paul Hunt replied to Paul Hunt's discussion Internal Compass not showing up
"I ran a test this afternoon. In the first, I had the external compass connected via the I2C port.  I did the calibration wizard. I could see the left window update as I moved the copter around. The right window/axes do not move.

When I am done, a…"
Aug 6, 2015
Paul Hunt posted a discussion
I just recently put together a quad build. I have used Pixhawk on a previous build and decided to use one on this build. I set everything up fine, did calibration, but sporadically got "Compasses are inconsistent" pre-arm warnings.I went back today…
Aug 6, 2015
Paul Hunt replied to Bob Loesch's discussion Pixhawk cabling questions - Newbee
"On first bringing this to the attention of customer service, I was given a document that didnt have much to do with the issue, on cabling. Then, I responded that the cabing doc didnt make sense and they verified I in fact was given wrong cables.…"
Mar 13, 2014
Paul Hunt replied to Bob Loesch's discussion Pixhawk cabling questions - Newbee
"I just ran in to the same problem. I ordered the exact same thing as you have listed above, and got to the point of hooking things up and noticed that the cables were wrong. With the Pixhawk, they only included 6 to 5 cables. I believe the telemetry…"
Feb 19, 2014