Randall Kolchins's Posts (1)

Sort by

What would you like to see in a thermal pan tilt platform to make it effective for UAV usage?


I am with a company called SPI Corp and we manufacture a low cost multi sensor pan tilt platform called the M1-D. The M1-D initially was developed for use on ground vehicles but due to its light weight, small size and low cost it has become very popular with folks in the aerial imaging world including both manned and unmanned craft. We are anxious to make this an even better product for UAV usage especially in the low cost market. We are reaching out to the UAV community for help in this endeavor (especially you guys at DIY Drones).  What we would like to know is what technical features would make our system even better for use in UAV's? If you could have anything you want in a low cost UAV Gimbal imaging system what would you ask for? What would be the bare minimum you would need to make the M1-D pan tilt thermal camera a workable UAV solution?  Current imaging systems are extremely expensive. It is our hope that by starting with our current low cost solution, and with a little help from the community, we can come up with a low cost UAV solution that will enable everyone to incorporate advanced imaging into their UAV project.

Our current system specs:

Fully enclosed pan tilt gimbal

Sensor Payload - Thermal Imaging, CCTV and Laser Pointer

Diameter of ball - 4.5"

Diameter of base - 5"

Height - 6.5"

Weight ~ 2lbs.

Pan - 360 degree continuous

Tilt - 90 degree

Pan Tilt Speed - Pan: 0.05~220°/sec; Tilt: 0.03~140°/sec

Video Output - Analog Composite single line NTSC or PAL

Communication Camera Control - RS/485 PELCO-D protocol

Inverted Mounting - Yes capable

Hardware specs such as size and weight are obviously difficult to change. What are the key features that you would need to integrate into your UAV project? Are there specific interfaces that are commonly used? Please post comments and let us know what you would like to see in the M1-D to make it even better for UAV imaging.

We look forward to your input.

Thank you

Randall Kolchins



Read more…