Hi everyone,
I am trying to use the buttons on my joystick to operate Lights and smoke on my rover/boat. I can use the extra channels to operate the lights etc via the X & Y axis on the Joystick but that leaves me on channel short. I have 7 extra but
Hi everyone,
I am trying to use the buttons on my joystick to operate Lights and smoke on my rover/boat. I can use the extra channels to operate the lights etc via the X & Y axis on the Joystick but that leaves me on channel short. I have 7 extra but
Hello all,
I am trying to set up a joystick to control my boat via 3RD radios. AMP 2.6, 3DR radio, Orange LRS for RC, joystick is a "Thrustmaster: T.Flight Stick X".
Following instructions: http://copter.ardupilot.com/wiki/flying-with-a-joystickgamepad
Read more…Hello all,
Because my boat doesn't have a water tight compartment I decided to 3D print cases and holders to keep my components dry in the event of water ingress. A couple of the cases are enclosed and the other two are open brackets that I use with b
Read more…I have just set up this 740mm power cat, AMP 2.5, NEO 7 GPS with compass.
Everything works great in manual but when I switch to auto the boat zig zags across the lay line, it makes the course but the course it steers looks more like a sail boat tackin
Read more…I'm using a APM 2.6 in a "Relentless" power cat. I would like to change the failsafe of loss of radio signal to RTL. Currently the default setting is "HOLD" which is rather unhelpful when the boat is on the other side of the bay.
Any help is much app
Read more…Moxon Antenna:
I am researching antennas for my GCS and I came across moxon on antennas and this tool to give you the dimensions for a moxon antenna for the frequency you input.
For any one else that is new to all this and is looking to get a better un
Read more…I have been trying to achieve this for some time with no success. I have to take long breaks due to work.
First I started out with a DroneCell / APM and even with the help of Soren Kula didn't achieve success before I had to shelve it for work.
Then I
Read more…Hello everyone,
I am looking for help!
I am a design engineer, specializing in composite structures. So building designing and building vessels for my project is the easy part.
My weakness is the APM and getting more channels to perform necessary tasks,
Read more…I am interested in using a joy stick with APM 2, please recommend joysticks and give feed back you your experience?
Read more…