"Thanks for the info, in my case I do not have a receiver to use for the binding process and only have the standalone satellite. Was hoping to avoid having to buy a full RX. When attempting to run the commands from the terminal (as referenced in…"
I am looking for guidance on how you would initiate a bind sequence via Mission Planner. I found a thread for the other firmware version for Pixhawk that mentions there is an option to initiate the bind sequence:…
"I am encountering a similar problem with my APM2.5 Power Module. I am using the same components, however I do not have an airspeed sensor. I am using a 900Mhz 3DR telemetry radio as well.
Everything powers up fine off the APM, but if I have my…"