About Me:
I am working with the ArduPilot Mega for the student AUVSI competion
About
Please tell us a bit about your UAV interest
I wish to design and create as a job when i graduate
Activity Feed
"In answer to your question, I am using the v1.0 of the APM and I am powering the board the same way in both the bench test and the flight test, and that is through the ESC. I am using the current version of the code, v1.02. I am also able to see…"
"I checked all the solder connection, and they all are good. Is there anything else that can cause a problem like this? Thanks for the idea I didn't think of checking that."
"Chris,
There are no differences in power or connections between the bench test and test with it inside the frame. Could it possibly be a hardware issue, because there are magnets near the system and it is near the battery. Could either of those…"
There are no differences in power or connections between the bench test and test with it inside the frame. Could it possibly be a hardware issue, because there are magnets near the system and it is near the battery. Could either of those…"
"Brad,
I am able to see the light switch when I change the position switch on my transmitter. It worked the all before it was placed inside the frame, like it was suppose to.
Chris,
In anwser to your questions,
1) Yes, the switch is in flight…"
I am able to see the light switch when I change the position switch on my transmitter. It worked the all before it was placed inside the frame, like it was suppose to.
Chris,
In anwser to your questions,
1) Yes, the switch is in flight…"
When I bench test my ArduPilot Mega board, it works until I try putting it inside the Easystar. I did not change the code on the board at all between the bench test and placing all the components inside the frame. After it is placed inside the…
