Location
Boston, MA
About
About Me:
UAS PRO
Please tell us a bit about your UAV interest
Fixed wing with some Multi-copter interest
Hometown:
Boston
Activity Feed
"RC10=1
The radio is just 9 channel. 4 motor channels 1 flight mode channel and 1 (working) servo channel leaves me with 3 unused channels. Surely RC10/AUX2 doesn't have to be an actual Transmitter channel 10 right? Couldn't it be TX channel 6,7,8,9?…"
The radio is just 9 channel. 4 motor channels 1 flight mode channel and 1 (working) servo channel leaves me with 3 unused channels. Surely RC10/AUX2 doesn't have to be an actual Transmitter channel 10 right? Couldn't it be TX channel 6,7,8,9?…"
"In any event, no matter the BRD setting, AUX1 and AUX2 stay the same. Shouldn't enabling RC10 turn on the servo function of AUX2?"
"I have not messed with BRD_ settings. Oddly enough I am getting the desired response on AUX1.
I'll go mess with BRD for RC10"
I'll go mess with BRD for RC10"
I am trying to run servos off AUX1 and AUX2 outputs on the Pixhawk. I have enabled RC9=1, and have been able to get a servo to respond on the AUX1 output of the pixhawk. So naturally, I would assume that I could go RC10=1 and get another servo to…
"I've installed firmware successfully.
The next button down is "3DR RADIO" which displays a host of different fields between "LOCAL"and"FIELD" radios. Is "mandatory setup" a button like "Firmware" and "3DR Radio"? I only have the two buttons…"
The next button down is "3DR RADIO" which displays a host of different fields between "LOCAL"and"FIELD" radios. Is "mandatory setup" a button like "Firmware" and "3DR Radio"? I only have the two buttons…"
"First timer so I like the Wizard route.
Just to be clear I am using and the problem is with APM not MP!"
Just to be clear I am using and the problem is with APM not MP!"
I am running APM 2.0.17 on MAC and I am not seeing the mandatory setup wizards. Searching around I see a similar problem from A YEAR AGO and wonder if this is just how it…
