About

Gender

Male


Location

Nederland


Please tell us a bit about your UAV interest

Quad for photography


Hometown:

Bant


Activity Feed

Ted Hoenderdos replied to Nick Phan's discussion Quadcopter APM 2.8, flip over when lift off
"In complete  agreement  with the last post of  RMAviation I will end my contribution to this thread because firstly I have given all my information and secondly the opinions differ to much to usefully debate any further.
Kind greetings, Ted."
Jul 16, 2017
Ted Hoenderdos replied to Nick Phan's discussion Quadcopter APM 2.8, flip over when lift off
"Please enlighten me how burning lipo's illustrate the danger of holding a quad above your head.
The same thing for losing fingers if you hold this type of quad by its landing gear with welding gloves (you know how they look and feel?).
The danger of…"
Jul 16, 2017
Ted Hoenderdos replied to Nick Phan's discussion Quadcopter APM 2.8, flip over when lift off
"RM Aviation replied to Nick Phan's discussion "Quadcopter APM 2.8, flip over when lift off" on DIY Drones------------There is no need to remove the comment, it's not recommended and can be very dangerous if protective equipment is not worn but it…"
Jul 15, 2017
Ted Hoenderdos replied to Nick Phan's discussion Quadcopter APM 2.8, flip over when lift off
"The following is NOT the recommended procedure but has helped me sometimes .
Find a brave person and have him/her hold the quadcopter straight above their head with its front facing forwards. Start the copter in a non gps mode (altitude mode), put…"
Jul 13, 2017
Ted Hoenderdos replied to Doug Adduci's discussion Warning! Don't Try This At Home Kids (radio fail safe test disaster)
"In openTX you can turn any switch and throttle warning off for each separate model."
Aug 14, 2016
Ted Hoenderdos replied to mark's discussion Does anyone have Failsafe working using the Turnigy 9X in ArduCopter User Group
"I had the same problem. The problem was if you switch the transmitter off then the receiver gives no output on channel 3 (throttle) , but on the other channels it still maintains the last output. If you have an AMP where the PPM encoder has still…"
Oct 13, 2013