Gender
Male
About
Location
Albuquerque, NM
About Me:
Experimental aircraft,full size. Built Rutan Long Eze
Please tell us a bit about your UAV interest
I would like to adapt a rc autopilot to a full sized aircraft.
Activity Feed
"If you haven't decided on a efis look at talos avionics a-efis....best introductory efis....works well....
I never used fy21.....I went to the trio system
If you are building a pulsar composite you are going to be busy....do yourself a favor and…"
I never used fy21.....I went to the trio system
If you are building a pulsar composite you are going to be busy....do yourself a favor and…"
"I use navaid servo....smooth....works in wing leveler and in nav mode to intercept a course line or go direct to navaid with the lowrance gps with command bars to the stating....it is as smooth as the more expensive avionics I have used in bigger…"
"What kind of aircraft are you building? I was going to adapt a Fulani fy21 radio controlled ap. I studied systems...looked at servo application that would have torque to handle my longeze aircraft. The problem was the disconnect and the ability to…"
"I was going to adapt a UAV autopilot but decided to install the trio autopilot system in my aircraft"
"That is great....no resistance without voltage. It is hard to see from picture but for pitch and roll this plane uses a side stick. It will be easy to fix a quick release pin in the event of a jam.
What lb/inch settings do you use for roll? Is the…"
What lb/inch settings do you use for roll? Is the…"
"I have my gps hooked up via Bluetooth and dual electronics to ipad plus I have a oil temp probe that works via Bluetooth.
I wonder if the Bluetooth configuration you have would create any interference? I need to get the frequencies.
Thank you for…"
I wonder if the Bluetooth configuration you have would create any interference? I need to get the frequencies.
Thank you for…"
"Mr Buhu.....if possible could you give me a list of part numbers you used on your autopilot including what kind of autopilot interface you used?
1. What is the torque on your stepper motor? When no voltage applied can you move controls or do you…"
1. What is the torque on your stepper motor? When no voltage applied can you move controls or do you…"
Looking for gyro/servo for a wing leveler. Need about 12 lb/inch torque. The gyros for camera look promising but not enough torque. I just want to build a simple wing leveler for full size rutan longeze.image.jpg
