Please tell us a bit about your UAV interest
3d printed drones
About
Hometown:
Bra
Activity Feed
"It works now! Thanks for you time, missed cabel, I blindly beleive that the manufacturer has right order of cabels... Clifton Hipsher said:
You have the cable miss-wired. The Yellow wire should be one slot over so that going from right to left …"
You have the cable miss-wired. The Yellow wire should be one slot over so that going from right to left …"
"Could be?
Clifton Hipsher said:
Sure the Pixhawk could be bad, but I have doubts about that which is why I'm focused on the receiver, how the receiver is setup, which firmware you are using on the radio and receiver, and especially how you have…"
Clifton Hipsher said:
Sure the Pixhawk could be bad, but I have doubts about that which is why I'm focused on the receiver, how the receiver is setup, which firmware you are using on the radio and receiver, and especially how you have…"
"Pixhawk cannot be bad themselves? Clifton Hipsher said:
Pixhawk should be fine with either S.Bus or CPPM, so either you have the input cable 180 out, there is an open between the Signal wire and the Signal pin on the RCIN port, or the RX is just…"
Pixhawk should be fine with either S.Bus or CPPM, so either you have the input cable 180 out, there is an open between the Signal wire and the Signal pin on the RCIN port, or the RX is just…"
"Frsky Taranis QX7 with Frsky R-XSR Clifton Hipsher said:
What radio and receiver are you using?"
What radio and receiver are you using?"
