Gender
Male
About
Please tell us a bit about your UAV interest
Quadcopters, control, visual analysis
Hometown:
Warsaw
Activity Feed
"Thank you. #1 Did not provide power to the servo rail. Changed it but still does not work.
#2 Yes it is on ch3. "
#2 Yes it is on ch3. "
"ESC beeps when there is no PWM but does not beep when there is a signal. It does not beep when I connect it to Pixhawk signal output so it means it must be getting some kind of signal from pixhawk. It beeps though when I disconnect it from Pixhawks…"
"Thank you for your reply. I checked it and even tried both ways to make sure, did not work. Also motors don't beep while connected to signal output so there must be some kind of zero throttle signal there."
"Thank you. I am not using 5V power leads. I have only GPS and 3DR telemetry connected to pixhawk which is connected to the pixhawk supply module. I will test the output signal with oscilloscope tomorrow."
"I tried full throttle with props :) Fortunately did not work. I am not sure what you mean by esc calibration from radio command. I have calibrated them by connecting to the receivers throttle channel."
I am able to arm the Pixhawk both through telemetry and transmitter - the diode is solid green and pre arm check is successful. Unfortunately motors do not respond to throttle and do not spin at all.Things I tried: - I have calibrated my RC and…
