Hello,
I have an APM 1.0 board that gets power from an ESC, LIPO battery 11.1. I have connected 3 servos, xBee, Mediatek GPS and the RX to the board. When I'm in manual mode I don't have any control over the throttle. When I mode the stick to 25%, 50
Hello everyone,
When I power APM from a battery through the esc/bec, the board has the leds flashing when is doing its calibration, is it normal that during the calibration or after the calibration to restart the calibration process when I plug the u
Read more…Hello Everyone,
I'm trying to run a simulation using X-Plane to get comfortable with the RC system. I'm unable to get an output graph for the servos in APM Planner, even though the servos are connected through APM and they move when I move the sticks
Read more…Hello everyone,
Last night I took my laptop outside to test my telemetry in conjuction with the gps. The Oilpan was connected to the laptop and gps and xbee pro 100 wire antenna were connected to it. I think I had a loose cable to the oilpan because
Read more…Hello Everyone,
this is what I have and what I have done.
I have APM 1.0 (running the the 1.02), Mediatek GPS with the 1.6 firmware. I enabled the line and added the 16 to the APM_Config.h
#define GPS_PROTOCOL GPS_PROTOCOL_MTK16
When I plug one end of
Read more…Hi guys,
At my school, there have been a few senior projects related to UAVs.They were good projects except they were never completed either due thecomplexity of the project or complications along the way.
After this frustrating scenario, two friends
