Gender
Male
About
Location
Leiria
Please tell us a bit about your UAV interest
Interested in multirotors for Ap/AV
Hometown:
Leiria
Activity Feed
"Very inspiring post! So much done already and the results are looking good.
Would pulling COG forward by slightly opening the masts angle, shortening the tail length and pushing the center plate forward compromise any of your prerequisites?
And…"
Would pulling COG forward by slightly opening the masts angle, shortening the tail length and pushing the center plate forward compromise any of your prerequisites?
And…"
"In your X2 design the overlapping tubes are great for structural stability but, and I'm only guessing, isn't there a problem due to the height difference between rotors?"
"Regarding your question, I have a quad so no personal experience with neither hex nor octa.
My decision to build a hex was basically to reduce the cost and have slightly larger unobstructed angle of view for the camera. Did consider the Y6…"
My decision to build a hex was basically to reduce the cost and have slightly larger unobstructed angle of view for the camera. Did consider the Y6…"
