Gender
Male
About
Location
Jerusalem
Please tell us a bit about your UAV interest
Build my own and shoot (360Video movies :) from the sky
Hometown:
Jerusalem
Activity Feed
"Thank you Phillip
If I'll replace to Turnigy 4225-610 motors (with the current 4S 6000mAh & 30A ESC's & 1355 inch prop's)
Would I be able to add a 2KG payload (or even 4KG?)
What flight time should I expect?"
If I'll replace to Turnigy 4225-610 motors (with the current 4S 6000mAh & 30A ESC's & 1355 inch prop's)
Would I be able to add a 2KG payload (or even 4KG?)
What flight time should I expect?"
"Hello
eCalc has gave me "Your Setup is unrealistic and way out of Limits!" (I didn't found my motor and pick Turnigy Multistar 350kv instead)
Yes a smaller motor (700kv) gave me realistic result but the motors is the last thing I'll want to change…"
eCalc has gave me "Your Setup is unrealistic and way out of Limits!" (I didn't found my motor and pick Turnigy Multistar 350kv instead)
Yes a smaller motor (700kv) gave me realistic result but the motors is the last thing I'll want to change…"
"In Stabilize it looks like the worst problem.
In AltHold it actually started to take of for 2maters for 5 sec (but than I land it since the wind was very strong today.
What can we conclude from all of that? "
In AltHold it actually started to take of for 2maters for 5 sec (but than I land it since the wind was very strong today.
What can we conclude from all of that? "
"Dear Robert
Thank you for your answer.
Currently my Tarot680 frame will only allow bigger blades if I'll turn around 3 arms 180 degrees.
So I'll have 3 motors up and 3 motors down (the blades should be all up of course)
The blades will not be level…"
Thank you for your answer.
Currently my Tarot680 frame will only allow bigger blades if I'll turn around 3 arms 180 degrees.
So I'll have 3 motors up and 3 motors down (the blades should be all up of course)
The blades will not be level…"
Hello Dear FriendsI've build an Hexacopter based on Tarot 680Pro frame.The problem Is that It doesn't take off at all (80% throttle until it actually start trying to)I've calibrate the Remote (via Mission Planner) and the Esc's and It looks like It…
