About
Activity Feed
"Well, my original 8mz board has arrived back (thanks Jordi) and works perfectly.
The 16mz continues to do the same thing - It's not just the MikroKopter, it's the same on my Conrad quad also.
I've checked connections again and again - replaced the…"
The 16mz continues to do the same thing - It's not just the MikroKopter, it's the same on my Conrad quad also.
I've checked connections again and again - replaced the…"
"Well, I strongly suspect that the first board I bought was an 8mz with 16mz firmware - It tallies very well with your experience of the symptoms (2/3 levels in MK tools - I didn't try to fly it like that).
It's been nearly 3 months now since my…"
It's been nearly 3 months now since my…"
"No Chris, the throttle on channel 3 is connected to channel 3 on the encoder - absolutely 110% certain on this.
Checked it with a servo on channel 3 on the rx as well...
This is what is wierd!
Thanks for the rest of the info though, I have read the…"
Checked it with a servo on channel 3 on the rx as well...
This is what is wierd!
Thanks for the rest of the info though, I have read the…"
"I've just found when testing with the rx that if I hold my roll stick far right on startup then I get the expected led blinking, so it's looking more like sofware/config than a hardware fault.
Khalid/Markus, maybe try starting up with various stick…"
Khalid/Markus, maybe try starting up with various stick…"
"OK, I have tx and rx on servo inputs one and two (tried both ways round, of course, but I know what it should be), 5v power via the usb ttl adapter, jumper on pins 4 & 6 of the programming pins.
The usb ttl adapter has leds for tx and rx, when I…"
The usb ttl adapter has leds for tx and rx, when I…"
"Thanks Chris.
Yup, that's what the docs say should happen. Mine was sitting there with the LED on continuously, no flashing, all channels connected to a bound and working (checked with servo on throttle channel 3, which I believe is the important…"
Yup, that's what the docs say should happen. Mine was sitting there with the LED on continuously, no flashing, all channels connected to a bound and working (checked with servo on throttle channel 3, which I believe is the important…"
"Same here, blue LED on the whole time, no ppm output. Also, nothing when jumpered for serial connection.
Flashed latest firmware via ISP, still no serial connection. Will test it for ppm later today, but I'm beginning to come to the conclusion it…"
Flashed latest firmware via ISP, still no serial connection. Will test it for ppm later today, but I'm beginning to come to the conclusion it…"