luke hegeman's Discussions

luke hegeman's Discussions (3)

Sort by

Oscillation / Motor issue

Hello forum -I'm using ardupirates latest release and have PID values at default settings.When I arm the motors and try to get it to lift off it tilts in the same direction every time. I've tried adjusting the PID values in acrobatic mode and that ha

Unresponsive Roll values

When in the initial configurator screen all of my values respond as I move the copter around. When I go to the screen where you move the receiver controls, the roll does not change. I decided to test out the quad by taking it an inch or two off the g

immediate spin up. no roll axis in configurator

this is my configuration:motors: TR 28-30B 14A 1050Kv Brushless OutrunnerESC: HobbyKing 20A BlueSeries Brushless Speed ControllerArduPilot Mega: Arduino Compatible UAV Controller w/ ATMega1280ArduPilotMega: IMU Shield/OilPan Rev-H (With Pins)Magnetom

Hello, you need to enable JavaScript to use diydrones.

Please check your browser settings or contact your system administrator.

Oscillation / Motor issue

Unresponsive Roll values

immediate spin up. no roll axis in configurator

Note: this page contains paid content.