My Arducopter has a problem with motors, when using yaw. While hovering everything seems to be allright, but when I use a little rudder stick something wrong happens with motors: all incerase speed gradually, and when I try to reduce speed (throttle
Read more…APM v2.5.4.
I don't understand some strange motor behaviors.Maybe it's PID issue? Without touching or moving quad I could notice two oposite motors slow down rapidly after few second. Quad tries to turn fast in Z axis. It happen itself only under a
Read more…While hovering I noticed all motors shut down few times and started again after about 1sec. I power AP board, Reciver and Roll/Pitch servos separately from different ESC BEC (with common GND only). There shouldn't appear brown outs. So what's the r
Read more…I wonder if the common GND is correct in this case. Should I change something? All parts powered separately (seems for me to be good). But as I mentioned in other topic I have strong servo twitching only during the flight and I'm not sure if it's so
Read more…I observe strong camera-servo oscilation, only when the throttle stick is in the middle position and the motors are armed (instead of ESC i plugged 4 servos and they are undisturbed). Annoing! I tested on BEC 5.1 and 4x NiCd 4.8V and discovered tha
Read more…I still can't set up my AC board properly or do something wrong. When I started motors slowly on the ground I noticed very strong dangeraous thrust changes without any stick input. It Looks like some strong noises. The same day I repeated the test an
Read more…I'm looking for a stable software with acces to all Camera parameters (end-point, neutral position, angular speed, reverse) in APM Planner. Which AC software version could you recommend? Currently I use software ver.2.0.39 and there are some paramet
Read more…