Gender
Male
About
Location
Seattle, WA
Please tell us a bit about your UAV interest
3DR Y6
Hometown:
Seattle
Activity Feed
"2 weeks and 2 wires later, turns out it was a defective wire between the PPM Sum and the receiver. I told everyone in post 1 it was going to be something stupid."
"Disconnected everything except the PPM and the USB cable, Radio Calibration page remains the same. There are values, the DX7s is solid orange and full throttle does nothing. It would be a heck of a lot easier if one of the 4 systems would indicate…"
"Was able to get the firmware updated to 3.2 no problem, but the original issue remains. Was attempting to disconnect everything and damaged my buzzer cable, so I guess I have something to do tonight. :("
"I don't have another radio currently, was hoping to avoid that by exhausting my options here first and making sure I wasn't doing something stupid on my end first.
Regarding the firmware, I am assuming you are referring to step 3 outlined here…"
Regarding the firmware, I am assuming you are referring to step 3 outlined here…"
"Thanks, I meant I plugged the satellite from the AR8000 into the SPKT port, but I should have been more specific. That was my initial setup before I ponied up for the PPM encoder and followed these instructions:…"
Greetings all. First post so bear with me, I'll try to make this as descriptive as possible to help a poor soul who follows me down my path of pain. I'm building my first 3DR Y6B UAV and am running into issues calibrating the radio, or at least I…
