A detailed look at Pixracer

The video below (enable audio!) shows a detailed overview of the new Pixracer flight controller.

It is the 4th generation of the Pixhawk flight controller family (make: FMUv4) and like the first generations designed by the Pixhawk Open Hardware team in collaboration with an international dev team. It supports the PX4 and APM flight stacks. If you like to try PX4 on it, follow the user guide.

E-mail me when people leave their comments –

You need to be a member of diydrones to add comments!

Join diydrones

Comments

  • 3702206447?profile=original

  • Thank's Richard, here is to 3dprint http://www.thingiverse.com/thing:1376555 ...if you have a 3d printer :)

  • I can't seem to get the wifi module to work. AmI the only one? I see the network. It asks for a PW I enter Pixracer... it says it connected... but no data transfer . Using Max OS X 10.10  APM Planner 2.0.19 rc5. I have try my Mac, my iPhone, and a Droid Tablet with Droid Planner and Tower same issue with all devices. 

  • Here's a case http://www.ebay.com/itm/231861641348

  • Thank's Philip, another little question, px4 osd uses the same code than minim? Do you ship by Fedex?

  • Cala, Stock level should stabilize by the end of March. A large number of EU preorders will ship out tomorrow.  Then a US batch the end of the week. Followed by more over the next week or two as more boards are tested and certified. Thank you to everyone for their patience.

  • An idea when is going to be in stock again?

  • They are standard Dupont connectors, usually coming with Servos and ESC. See them at the Pixracer Instructions page pics on http://px4.io/docs/pixracer/

  • Hi all,

    I get my pixracer today. it looks good and a wlan module was included.

    what I missing are this servo connection pins, where can I get this pins?   

    many thanks,

    Alex

  • I see. Your solution provides impact protection as well and the Baro foam can be squeezed in between.(One of my favourite topics as well)

This reply was deleted.