After HK's Mini clone, Here is another APM mini clone.
Here you can read more about it.
Specs are not mention , I suspect if it is using same 2560 Mega.
With GPS it is only $81 , more cheaper than HKs.
Did it with trying on my beloved copters ?
After HK's Mini clone, Here is another APM mini clone.
Here you can read more about it.
Specs are not mention , I suspect if it is using same 2560 Mega.
With GPS it is only $81 , more cheaper than HKs.
Did it with trying on my beloved copters ?
You need to be a member of diydrones to add comments!
Comments
LOL
http://www.goodluckbuy.com/3dr-pixhawk-autopilot-system-flight-cont...
Do they do that just to make their clones look really well priced?
It seems that goodluckbuy has a lot of Ardupilot and Pixhawk compatible boards and accessories.
Ardupilot
http://www.goodluckbuy.com/index.php?target=products&mode=searc...
Pixhawk
http://www.goodluckbuy.com/index.php?target=products&mode=searc...
Yup.
and it is with ATMega2560.
its v2.6 with external compass.
Here is another one: http://www.goodluckbuy.com/miniapm-v3-1-mini-ardupilot-mega-2-6-ext...
35*35 mm
Just add a GPS
turdsurfer +1
Rana +1
I wish 3DR would make APM boards in these small form factors but they don't. At least then it would come with a manual and warranty. PX4 is close though size-wise. I'm not going to buy this, but I have several models (gliders and mini aircraft) where tiny flight controllers like these will just fit into. Smaller models are also much cheaper in many aspects, and can usually take more of a beating too.
It is the same controller as in the Cheerson CX-20
81$ with GPS is not cheap. I got two APM2.52 clones from e-bay, 42$ each and same GPS for 20$. Both the clones are working ok.
There is nice thing there Quanton Flight Controller 32bit ARM Processor in 91$ and CC3D Openpilot in 62$
- With one key returning, one key turning and out of control and return models etc.
- The GPS can get the point-set high-set easily and stability