Some nice custom foam design on the plane and camera pod here. Looking like they're going to be selling them. 

 

Views: 2240


Moderator
Comment by Brian on January 14, 2011 at 5:25pm
More Please!
Comment by ^^Johnny5 on January 14, 2011 at 5:37pm
Where can I get this plane?
Comment by Allan Harley on January 14, 2011 at 8:01pm
yeh im interested in this one

Moderator
Comment by Gary Mortimer on January 15, 2011 at 1:03am

There are hundreds of useful plans on RCG this one has fantastic instructions, so off to the hardware store for some foam ;-)

 

I wonder why this community seems to roundly fail when it comes to a group airframe. The ratio of fliers to programmers is perhaps wrong (expecting flames for that)


Admin
Comment by Thomas J Coyle III on January 15, 2011 at 8:06am

Hi all,

Take a look at this EPP FPV model from Poland: http://www.rcgroups.com/forums/showthread.php?t=1325273&highlig...

It sells for a little over a $100 USD plus shipping. It is a complete kit. Just add servos, motor, battery, and receiver. I have the XXL version on pre-order for shipment near the end of January.

Regards,

TCIII


Moderator
Comment by Brian on January 15, 2011 at 7:35pm

@Gary - Simple,  too many good opinions as to what a small uav should be able to do...


Admin
Comment by Thomas J Coyle III on January 15, 2011 at 10:15pm

@Gary,

They usually wind up being beyond most users' budgets because they are usually a "do all" design or there is no follow through from the party (think Gemma Jane here) that is committed to supplying the kits.

I like the Polish URSUS mentioned in my post above because it flys well, has plenty of interior room, can be customized and is of reasonable cost. It also has a large following on RC Groups.

Regards,

TCIII


Moderator
Comment by Gary Mortimer on January 15, 2011 at 10:59pm
That URSUS certainly does look the business. I think the airframe should be designed to do one task and be able to survive! You have to have lots of tools in the box to get a range of tasks done. There is no one size fits all.
Comment by Ramon dime on January 18, 2011 at 8:58pm
Looks good do you have pdf plans for it !!!!!!!!!!!

Comment

You need to be a member of DIY Drones to add comments!

Join DIY Drones

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service