You need to be a member of diydrones to add comments!

Join diydrones


  • Distributor

    Very nice, and neat install.  It almost looks like the electronics are missing from your Hexa when you put attach the top plate.

  • @George P. - If you twist all cables (plus with minus,motor cables), lot of EMI will be canceled;however 2-3 deg error will be in compass when motors are spinning but can be removed in software.

    @Crispin - Thank you.

  • That looks neat. the 3DR ones look like they vomited thier intestines. I'm trying to make mine look neat :(

  • In general, it is recommenent to place the ESC's as close as possible to the motors.

    Otherwise too much electric noise may radiated and interference with other sensitive electronics.

  • Very nice.

    Do you have moreinfo on the AP board?

This reply was deleted.