Hi,
This is 1st outdoor flight of Xmega Lite AP . All electronic components are located inside, between carbon plates.
Below, first outdoor flight; no landing gear yet...
Cheers,
Sergiu
You need to be a member of diydrones to add comments!
Hi,
This is 1st outdoor flight of Xmega Lite AP . All electronic components are located inside, between carbon plates.
Below, first outdoor flight; no landing gear yet...
Cheers,
Sergiu
You need to be a member of diydrones to add comments!
Comments
Very nice, and neat install. It almost looks like the electronics are missing from your Hexa when you put attach the top plate.
@George P. - If you twist all cables (plus with minus,motor cables), lot of EMI will be canceled;however 2-3 deg error will be in compass when motors are spinning but can be removed in software.
@Crispin - Thank you.
That looks neat. the 3DR ones look like they vomited thier intestines. I'm trying to make mine look neat :(
In general, it is recommenent to place the ESC's as close as possible to the motors.
Otherwise too much electric noise may radiated and interference with other sensitive electronics.
found it ;-)
http://diydrones.ning.com/profiles/blogs/xmega-ap-and-esc
Very nice.
Do you have moreinfo on the AP board?