The Pilot Viper 300 - Inspiration of the local DNA-

PilotViper300-1080.png?width=702

-Pilot Viper 300-

Digi-DNA-300-PilotViper.gif?width=600

Shown without the landing gear and 3d camera array.

3D FPV, dynamic driven landing gear.

Dual purpose Tail assembly, aerial/gear parts in process...

The landing gear assembly inspiration was the trap jaw of the South Carolina "Cottonmouth"

As this will be a active post with frequent updates. pictures of the linkages.

Interior Dimensions allow for Pixhawk, VR Brain, VR Brain Micro without any modification.

digi-dna.net 

(the props are on the wrong way, had been in virtual model land long enough)

snapjaw-300-HD.gif?width=702A quick crop of a semi deconstructed view, helping picture it as a H4 setup 

E-mail me when people leave their comments –

You need to be a member of diydrones to add comments!

Join diydrones

Comments

  • Do I see vibration damping in the image?

  • IMG_20150317_092714.jpg?width=600

  • IMG_20150317_091313.jpg?width=600

  • I have that in the one I have built up. So far I have a few more I need to make for the early adopters, email me and we can coordinate

  • @ Tearig,

    I'm planning to use the VR Brain Micro.

  • contact me via casey.bearsch@digi-dna.net

  • Hi Tearing,

    I have a spare electronics set ready for a frame to test. if you can cut me a frame , I would be happy to test your frame. I have a range on 36mmx36mm board I can test the frame with.

  • I can cut more frames as needed, the platform is ready, what FC do you plan to use so I can cut the right tray

  • @Tearig,

    Any luck with the frames?  I have parts to outfit a 4th frame and I would like to test your design out for a FPV racer as a quad design.  Any dates when the design can be tested?

  • Wou, the frame looks great, I just ordered parts for a similar project. I'm gonna build mine out of wood first to be able to adjust the boom length and frame geometry more easily. I'm trying to think of a way to allow modular/adjustable placement for vtx/rx/gps/batter/ect.so that you can correct the balance based on the gear you have on. Also I wanna have some way to adjust the motor angle on-the-fly. I'll start a blog when i get the parts and the project started.

This reply was deleted.