UgCS integration with ADS-B and 3D Robotics Arducopter

Today we again sucessfully flew Arducopter with ADS-B transmitter. Flight was detected on Flightradar24.com along with other aircraft.

Our Arducopter has formal and legal ICAO registration and probably is first in its class in the world to get formal ICAO ID.

We used microADS-B reciever and our UgCS software to monitor the mission. In paralel also used Sagetech Reciever (screenshot)

Please see whole mission in our video

Thanks,

UgCS Team

Views: 2569

Comment by Alexey Dobrovolskiy on January 19, 2015 at 2:24pm

Photo of our transponder equipped copter (with transponder antenna)

Comment by Rostislav Kolotov on January 19, 2015 at 3:57pm
Alexey,
This is a one piece of long antenna!!!!
Could you share transponder setup and spec.
Way to go.!!!!
Comment by Rostislav Kolotov on January 19, 2015 at 3:57pm
Alexey,
This is a one piece of long antenna!!!!
Could you share transponder setup and spec.
Way to go.!!!!
Comment by Alexey Dobrovolskiy on January 19, 2015 at 11:02pm

Hi,

little bit later we will publish all information including schematics and source code. 

Comment by Jethro Hazelhurst on January 26, 2015 at 2:49am

10/10, these are key steps toward full commercial integration, thanks for sharing.

Comment

You need to be a member of DIY Drones to add comments!

Join DIY Drones

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service