Hi there,
I must say that I am very impressed by your quad rotor design.It sure must have taken months to build up one.I myself tried building a quad rotor using only RC components and it was somewhat successful.However, there were drawbacks such as gyro sensitivities and instability of the whole design by itself.
Thus, I opted to redesign a quad rotor after I was inspired by a team from the University of Chicago that did it.
However, in my drawing board now, I am stuck simulating using Lab view.I was wondering if you had any knowledge on this matter and maybe you could help me see what inputs are wrong.Is it possible if we communicated through email?
Comments
I must say that I am very impressed by your quad rotor design.It sure must have taken months to build up one.I myself tried building a quad rotor using only RC components and it was somewhat successful.However, there were drawbacks such as gyro sensitivities and instability of the whole design by itself.
Thus, I opted to redesign a quad rotor after I was inspired by a team from the University of Chicago that did it.
However, in my drawing board now, I am stuck simulating using Lab view.I was wondering if you had any knowledge on this matter and maybe you could help me see what inputs are wrong.Is it possible if we communicated through email?
Regards,
MAVERICK