Gender
Male
About
Please tell us a bit about your UAV interest
Just started to play with motors, ESCs and arduino. Here is my blog where I file my progresses (unfortunately I started before knowing I could start a blog right here on diydrones : http://pro-mente.blogspot.com/search/label/quadcopter
Activity Feed
"Hello,
I have soldered the ESC directly to the motor and it runs ! :)
I tested with the power supply and with the battery 3 cells lipo.
*However*, it does shut down if I try to run it too fast. When it happens, decreasing the speed doesn't make it…"
I have soldered the ESC directly to the motor and it runs ! :)
I tested with the power supply and with the battery 3 cells lipo.
*However*, it does shut down if I try to run it too fast. When it happens, decreasing the speed doesn't make it…"
Hello,I have 4 arducopter ESC 20A and 4 motors (850kv, A-2830/12). Power is coming from a power supply 12V 2250mA. The input (white wire) of the ESC is connected to my arduino (pin 9) and the ground (black wire) to the gnd of the arduino. I use the…
"Ok, I think that I can confirm that my battery is incorrect. I should use a higher voltage, a LiPo 3 cells or something similar.
Cheers"
Cheers"
Hello,I have ordered an arducopter ESC 20A and a motor (850kv, A-2830/12) because I want to understand how it works and how to interface it to an arduino. In addition to these components, I have a battery 3.7V 2000mAh. I am pretty new to this things…
