Gender
Male
About
Please tell us a bit about your UAV interest
I am 13 years old and just getting started in UAVs. I gained interest when I found a quadcopter design online that I could make with my DIY 3D printer.
Hometown:
Austin
Activity Feed
"EDIT: Fixed it! Turns out I needed to completely reset the board. I'm not sure what was the problem was, but it's working fine now."
"I tried, but when I try to connect to it in APM"
Hi,When I arm my APM 2.6, it responds to my controls for only about 5 seconds until the motors start spinning at a low RPM. The motors continue to spin at that speed until I lower the throttle all the way down, then the APM disarms and refuses to…
"Okay, I figured it out. The throttle should have been plugged into channel 3. Now I just have to wait for the frame connectors to come. :)"
Hi,I'm new to this forum and this is my first post. I'm 13 years old and I'm just getting into the hobby with a DIY 3D printed multirotor.I have calibrated and setup nearly all of the components, now all I'm left with is calibrating the escs. When I…
