Gender
Male
About
Location
Methuen, MA
Please tell us a bit about your UAV interest
Using a Jdrones hexacopter for aerial photography. Jdrones Auducopter Hexa Kit V1.0 Assembled Hexa Motor; 880kv Props: 12x45 30amp esc 9ch wft 09 radio set Jdrones gopro 2 axis camera mount
Hometown:
methuen
Activity Feed
Ok I'm new to this forum so excuse me if some of my questions seem silly. I'm running 2.9 firmware on a apm 1 with all default Params, and I just installed the ublox gps and I get a lock even indoors. I'm holding my hexa (jdrones) in my hand and set…
"Ok so I need to get the FTDI to usb cable that Jdrones sells and Install the Arduino IDE, but which Arduino drivers do I install for the IO board? Thanks for the quick reply!"
"I'm a newbee here, how can I program the LED's? I have the io board connected to my APM1 board to the telemetry terminals tx to rx and rx to tx +5 and ground. Can I now use the usb connector on the APM1 to program the IO board? thanks, Mark "
