Gender
Male
About
Location
Bondi Junction, NSW
Please tell us a bit about your UAV interest
FPV
Activity Feed
Hi,I have just revived an old APM2.5 board and have flashed the latest firmware. All the sensors seem to work fine in the GUI. When I switch to stabilize mode the control surfaces move in the right directions but with full deflection, even with the…
"Cancel that I just been down the part to fly and sure enough overspeed again.. Does anyone have a solid solution???"
"Overspeed issue fix for me was to:
Clear the eprom
Reflash the firmware
Upload the Character set
Rewrite the settings for each page in the config tool (I think this was the step that seemed to fix it..)
Hope this helps someone.
Matt"
Clear the eprom
Reflash the firmware
Upload the Character set
Rewrite the settings for each page in the config tool (I think this was the step that seemed to fix it..)
Hope this helps someone.
Matt"
"Hi,
I am having the overspeed issue. Can anyone tell me if there is a fix and if so where to find it please..
Cheers
Matt"
I am having the overspeed issue. Can anyone tell me if there is a fix and if so where to find it please..
Cheers
Matt"
"Hey David,
I am using APM2.5. I have covered the baro sensor with some foam. I have been testing it in Rate/Acro mode. Is the Barometric sensor a factor in Acro mode?
Matt"
I am using APM2.5. I have covered the baro sensor with some foam. I have been testing it in Rate/Acro mode. Is the Barometric sensor a factor in Acro mode?
Matt"
Hi Guys,I hope some one can help me. I have spent quite a bit of time flying quads using multiwii and thought I would try Arducopter get some more functionality.I spent some time tuning my quad indoors using the method posted by Dave C. I then tuned…
"Thanks for the info Jumpy.
I have checked the Arducopter code for #define RECEIVER_RSSI_PIN and it does not exist. I am unsure what the current RSSI fields in MAVLINK are reporting but its not anything to do with a analog pin. Does someone know what…"
I have checked the Arducopter code for #define RECEIVER_RSSI_PIN and it does not exist. I am unsure what the current RSSI fields in MAVLINK are reporting but its not anything to do with a analog pin. Does someone know what…"
"Hi from Bondi Junction. Im looking forward to finding some other Arducopter flyers in the area."
Hi Guys,Is it possible to connect the pwm RSSI output from a Frsky RX to a APM 2.5 running Arducopter 2.8.1 ?Matt
