Dear all,
I am using a Tiger battery 4S 6000mAh 35C and I set the voltage failsafe in Mission Planner at 14.0V (3.5V per cell as suggested).
The problem is that from 50% of the discharge of the battery (3000mAh used), if the current request increases a
Read more…Dear all,
I don't find information about the "Change Speed" button is in the "Actions" tab in Mission planner. Is it the speed in m/s? Is it working correctly?
I did a test pressing it while flying with may multicopter to a waypoint with it set at 100,
Read more…Dear all,
I am setting a joystick to flight with the MissionPlanner and I saw there are a lot of available options for every button that can be selected from the dropdown menu. This is the complete list:
Dear all,
I have a hexacopter with a Pixhawk flight controller. I have decided to use an old Hitec 35Hz radio I had to control it with a PPM encoder and it does hits job, the problem is that it is too much disturbed by interference and I have risked t
Dear all,
I am setting up a drone with FPV via 3G USB modem connected to a Raspberry. The problem is that this modem is creating a lot of interference to my RC receiver, so it becomes quite hard to control the drone. The receiver is a quite old Hitec
Read more…Hi everybody,
I have bought the DJI E300 kit and the ESC comes with a coaxial cable for the power. In the kit there is already a distribution board, but the power cable are soldered, so it is not comfortable in case I want to remove something. I would
Read more…Dear all,I would like to build my first drone and I need some advice to chose the motors.My idea is to build an hexacopter with an empty weight of 2kg and a payload of 3kg, so I am looking for 6 motors with the right trust. I have seen the DJI E600 k
Read more…