Discussions

2.6.2 Stabilize Not Working

Posted by BriFly on July 10, 2010 at 8:33pm

I just tried out 2.6.2 with ArduPilot/IMU setup today and Stabilize did not function. whenever I switched to this mode the engine turned off. Any ideas?

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –

Replies

Developer

Jason Short July 10, 2010 at 11:05pm

Is this the release candidate from here?
http://diydrones.com/forum/topics/updated-262
3D Robotics

Chris Anderson July 10, 2010 at 10:11pm

Have you set up the board right, following the manual closely? (Cut pin D13 etc).

This reply was deleted.

Activity

Jose Araujo liked Jose Araujo's profile

spencer harvey liked spencer harvey's profile

More…

#xg { position:relative;top:120px; } #xn_bar { top:120px; }

Hello, you need to enable JavaScript to use diydrones.

Please check your browser settings or contact your system administrator.