Discussions

3 axis camera setup on APM 2.6

Posted by Keith hetherington on August 18, 2014 at 3:12pm

I have set up my 2.6 with roll and pitch on rc 10 and 11 as advised, and they work fine.  When I try to allocate rc9 for pan, Mission Planner won't recognise it. Is there something you have to do extra to enable this please? I am using analogue servos currently, but could switch to digital if required to sort this.
I simply cant find a blog that addresses the third (pan) servo at all. Help please!!

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –
Follow

Replies

  • 100KM
    Hein du Plessis August 19, 2014 at 3:59am
    I'm planning to use a 3 axis gimbal, three axis input
  • 100KM
    Hein du Plessis August 19, 2014 at 2:49am

    I'm about to try this, I hope you figure it out! Will post here if I get it to work.

    • Keith hetherington > Hein du Plessis August 19, 2014 at 3:49am

      Hein,

      Are you planning to use digital or analogue servos? It seems that all but A10 and A11 pins operate at a frequency that is only effective for digital?? Good luck......

This reply was deleted.

Activity