Gender
Male
About
Please tell us a bit about your UAV interest
Plane with 2.6 - just learning yet.
Hometown:
carlisle
Activity Feed
"Martin, will try again, thank you. I think IP stuff OK - ..005 out 000 in etc."
"Yes, I get data on all areas, but just the initialising red light flashing still!"
"yes I am running them on one PC"
"Also, in messages on Flight Data screen reads - Waiting for first HIL_STATE message"
"Rocket Man,
Tried APM Plane 3.1.0 (HIL?) again just now - loads up OK, but then remains initialising i.e red flashing!! Any more ideas please? Everything works perfectly on normal Plane 3.1.0 with correct lights GPS lock etc,,,, help,,,,"
Tried APM Plane 3.1.0 (HIL?) again just now - loads up OK, but then remains initialising i.e red flashing!! Any more ideas please? Everything works perfectly on normal Plane 3.1.0 with correct lights GPS lock etc,,,, help,,,,"
"Martin thank you for your reply,
When I look at the Firmware screen on 1.3.9 I see Plane as 3.1.0, but I also see HIL plane as 3.1.0 (without any HIL suffix)! Is this what you have please? I've tried it a few times, with the red APM light flashing…"
When I look at the Firmware screen on 1.3.9 I see Plane as 3.1.0, but I also see HIL plane as 3.1.0 (without any HIL suffix)! Is this what you have please? I've tried it a few times, with the red APM light flashing…"
"How do you open an issue please? Is it something the site administrators get involved with, or what? I would very much like the HIL failure to be looked at/resolved ASAP.
I am sure that we all appreciate the work done by the project teams, and hope…"
I am sure that we all appreciate the work done by the project teams, and hope…"
"Hein,
Are you planning to use digital or analogue servos? It seems that all but A10 and A11 pins operate at a frequency that is only effective for digital?? Good luck......"
Are you planning to use digital or analogue servos? It seems that all but A10 and A11 pins operate at a frequency that is only effective for digital?? Good luck......"
I have set up my 2.6 with roll and pitch on rc 10 and 11 as advised, and they work fine. When I try to allocate rc9 for pan, Mission Planner won't recognise it. Is there something you have to do extra to enable this please? I am using analogue…
