HI @ everyone i invented a small drone with lots of power that can easy be printed and could be used in many way´s.
i now looking for some guys to prove the construction and possible use in all thinkable ways.
Frame size
min. 320mm max 450mm
the setup
6 motors with 120-500+ watts each no problem
6x 12A-30A esc
4x 1300mah lipo
props 5-6 inch
Ready for pixracer / Pixfalcon
full telemetry possible
supports outputs in the bottom for 3 axis gimbal with additional powersuply.
bores in the bottom from 45x45mm and 35x35mm
all parts are easy to print excluding the 12mm boom arm.
speets up to 90km/h posible.
best of all it could be fully sealed so it could be used in tough weather for reserch.
motor mounts 19 by 16mm
so all fpv racing motors will fit easy and give lots of possibility.
setup currently 3S 4pacs in line.
if there is some intrest visit my patreon page to support me.
if there is some interest, visit my Patreon page to support me.
https://www.patreon.com/CraftsSam
Videos and pictures are in produktion
I am working on the prototype to get it fly and generate contend.
If you are a student and like to test the files try to contact me.
Replies