Discussions

After ARM reset strange throttle behavior

Posted by Richard Bickell on July 25, 2014 at 11:25am

Hi all - Following a reset on my ARM2.5 with the latest firmware and a fresh set up on my DX6i my 450 quad lifts off OK - however when I increase the throttle slightly the quad just keeps going up. I have a completely basic setup I have not programmed anything that I can see would cause this to happen. Strangely a few toggles of the throttle brings it down again where | have to increase it again to avoid a really heavy landing.

Does anyone have any ideas where I should start to look for the problem.

I had flown this quad for months without problems.

many thanks

Richard

You need to be a member of diydrones to add comments!

Join diydrones

Tags: problems, throttle
Email me when people reply –
Follow

Replies

  • Dean July 25, 2014 at 9:49pm

    I had this once and a re-bind of the receiver to transmitter fixed it for me

    • Richard Bickell > Dean July 26, 2014 at 2:45am

      Hi Dean You are a star, it fixed it for me also. So simple. I forgot one of my golden rules. When something goes wrong back to basics and go forward from there. Many thanks. Richard

      • Dean > Richard Bickell July 26, 2014 at 5:26pm

        No problem. Glad I could help. Have fun!

This reply was deleted.

Activity