Gender
Male
About
Location
Kent
Please tell us a bit about your UAV interest
Just started to convert my 450 quad with KK2 to Ardupilot 2.6
Hometown:
ORPINGTON
Activity Feed
"Hi There - this a bit of a long shot but did you manage to get an answer to your problem of no USB. I have the same problem and thought I may have read somewhere that it is possible to program the board some other way.
many thanks
Richard"
many thanks
Richard"
"That's great - love it when it all come together. Happy flying.
Richard"
Richard"
"Hi Todd - Everything was resolved for me by loading the latest beta version of MP. I think MP v1.3.10. will also sort things out for you now.
Let us know
Richard"
Let us know
Richard"
"Chris sorry I did not pick up your request earlier. It was time for the new garage roof before the winter sets in. pleased to see you have resolved the matter.
Happy flying
Richard"
Happy flying
Richard"
"Thanks Michael for your work on this. Everything appears good with the beta version even with .net 4.5."
"Hi - I to have just had this problem. I needed to replace the micro USB on my board which I did and just so happened to upgrade MP at the same time. I keep getting "There was an unexpected error" and 'Bad Firmware" when trying to upload hex profile.…"
"Hi Santosh - try rebinding the rx/tx it sorted a throttle problem out for me. Good Luck"
"Hi Dean You are a star, it fixed it for me also. So simple. I forgot one of my golden rules. When something goes wrong back to basics and go forward from there. Many thanks. Richard"
Hi all - Following a reset on my ARM2.5 with the latest firmware and a fresh set up on my DX6i my 450 quad lifts off OK - however when I increase the throttle slightly the quad just keeps going up. I have a completely basic setup I have not…
