Hi all,
I have been using the same alpha code for my arducopter. Since my arducopter was veru unstable therefore, i try to connect it to my configurator again to reconfigure it. But i discovered that the Accel roll, Accel pitch and Accel z axis got no reading at ALL. Which is unusual from what i have seem previously.
Therefore, i decided to clear the EEPROM and reload the code. Once, i am done i start to initialize the APM and the Accel roll, pitch and z axis will be at -2000 indicate. Artifical Horizon is tilt to the side and no moving even i move the APM.
Only response i got is the transmitter reading...
What have happen to my APM and IMU?
Replies
The gyro roll and gyro pitch is not moving at all both reading at 0.
I have done another round of eeprom clear and reload alpha rc code, then initalize eeprom in arducopter configurator. My accel roll, pitch and z axis will go down to -2000 immediately and gyro roll and pitch not moving.
On the oilpan A led is "green" lit up and RX led blinking. Others led seem normal.
Peter
abnormal.jpg
abnormal2.jpg