APM + Oilpan, log question

Hello,

Just received and tested my ardupilot in skywalker - works great!

One question:

When i got home after flying and tried to download logs i got 255 zero-sized logs.

Here's a tail of "logs" command output:

----------------------------------------------

Log number 1, start page -1, end page -2

...

Log number 252, start page -1, end page -2

Log number 253, start page -1, end page -2

Log number 254, start page -1, end page 3009

Log number 255, start page 3010, end page 3009

----------------------------------------------

when I download them, mission planner creates .log and .kml files for each, but they all empty.

All logging is enabled except altitude.

Maybe i'm missing some other setting?

Thanks

Developer

Doug Weibel January 16, 2011 at 12:20pm

Kolyan - I think your problem is simply because you must use the CLI command to erase the logs before the first time that they are used. Try that.
kolyan2003 January 15, 2011 at 4:53pm

GPS module is ublox with ardupilot-ready adapter.

When I test GPS i get correct information (down to couple of meters), but #sats in output always says "0" or "-1"

Tried resetting after GPS acquired lock - same situation.

Thanks
Distributor

Martint BuildYourOwnDrone.co.uk January 15, 2011 at 2:09pm

Hello Kolyan,

Which GPS unit are you using?

Did you do a warm start reset of the APM?

When you run a test on the GPS are you seeing the correct information?
Regards

Martin

This reply was deleted.

Discussions