About Me:
Skywalker + ardupilot mega + oilpan
About
Please tell us a bit about your UAV interest
my UAV interest is hobby based
Activity Feed
Hi,I've been trying to set up antenna tracking using Micro Maestro (http://www.pololu.com/catalog/product/1350)but so far wasnt able to make servos move.I followed these instructions: http://code.google.com/p/happykillmore-gcs/wiki/TrackingI can…
Hi all,I got my APM with 1.02 software tuned and functioning properly.Yesterday I tested airspeed sensor board (700 series) in light wind.added #define AIRSPEED_SENSOR ENABLED in APM_Config.hdid reset and setup radio/modes.t appears to work fine in…
"i took a voltmeter and connected it to power at the telemetry port: https://www.youtube.com/watch?v=U-wb5So6WE0 - voltage jumping between 4.97 and 5.07 - thats a clue!
Unplugged Ublox gps unit - rock solid at 5.23, airpseed became solid too.
Will…"
Unplugged Ublox gps unit - rock solid at 5.23, airpseed became solid too.
Will…"
Hi all,I'm getting readings from airpressure and airspeed sensor that are somewhat unstable.It happens when board powered up through USB only, BEC only, and through USB + BEC.readings from the sensors jump from 0 to 10m/s (airspeed) and from -0.3 to…
"hey it works!!! had to upload ardupilot version of OSD firmware. I too connected ground, tx and rx. Great job Blake!"
"Do i hook up TX of APM's telemetry port to OSD's RX and connect grounds?
Can I skip power and RX of APM to TX of OSD?"
Can I skip power and RX of APM to TX of OSD?"
"Easiest way probably would be a v-tail mixer, like this one: http://hobbyking.com/hobbyking/store/uh_viewItem.asp?idProduct=6321"
"GPS module is ublox with ardupilot-ready adapter.
When I test GPS i get correct information (down to couple of meters), but #sats in output always says "0" or "-1"
Tried resetting after GPS acquired lock - same situation.
Thanks"
When I test GPS i get correct information (down to couple of meters), but #sats in output always says "0" or "-1"
Tried resetting after GPS acquired lock - same situation.
Thanks"
Hello,Just received and tested my ardupilot in skywalker - works great!One question:When i got home after flying and tried to download logs i got 255 zero-sized logs.Here's a tail of "logs" command…
