Discussions

cant seem to arm motors

Posted by Rob. S on May 21, 2011 at 4:35am

i cant arm the motors led A doesnt even start flashing. it stays solid green.

i have calibrated esc gone through set up atleast 5x both in mission planner and cli
using acm2.06
the quad was flying perfect yesterday.
the only main change i made was updating firmware

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –
Follow

Replies

  • Kevin M. May 24, 2011 at 4:25pm
    Had this happen a few times when loading code. Re-run radio setup and don't push right really hard on the stick, then see if it will arm. I believe full right stick in calibration is more stick than what I was giving it to arm.
  • Rob. S May 21, 2011 at 2:51pm
    hey all i worked it out i had one of my dip switchs down and once i flicked it up i could establish motors.
This reply was deleted.

Activity

Neville Rodrigues liked Neville Rodrigues's profile
Jun 30
Santiago Perez liked Santiago Perez's profile
Jun 21
More…