I've had my APM for a while now - I got it in December 2010 and had it working basically, but never flew with it. I just started reprogramming and setting it up again and noticed that my first channel output isn't working (even in manual mode)... I reflashed the PPM/failsafe thinking that might be the problem but it doesn't seem to have fixed the problem.If I put logic analyser on the output of Ch 1 (labeled as 0 on mine) I don't seem to get any output - the signal line is low... however if I load the dancing servos firmware it moves all four servos.I'm not really sure where to look next - could it be a firmware issue? or have I set something up wrong? orrrrr ? :)Any pointers would be greatly appreciatedShaw
You need to be a member of diydrones to add comments!
Replies