Discussions

Posted by Raytrace Nomad on December 28, 2010 at 3:08pm

My steps

1- Connect RC channels

2- Connect USB and Configurator make Transmitter Calibration

3- Remove USB

4- Connect ESC cables to APM

5- Connect Lipo

6- Sound looks good and lights look ok.

7- Could change with mode GPS hold and could change to acrobatic to stable.

8- th Lower right change the light blinks [ acro mode fast and stable mode slow ] but motors did not move ?

9- Connect USB and configurator, and Motors work ?

Where i did a mistake ?

Futaba r607fs

Mystry 30a esc

indoor , gps not fixed

You need to be a member of diydrones to add comments!

Email me when people reply –

Greg Fletcher December 28, 2010 at 6:20pm

And the logo has flames ,lol- omg did i just use lol ?
Raytrace Nomad December 28, 2010 at 4:07pm

I try but i failed. Because Mystery Esc's will enter setup mode when powered in full th. When i wait for beep's its enter to setup mode and lower the stick will activate brake mode.
3D Robotics

Chris Anderson December 28, 2010 at 3:34pm

Did you calibrate your ESCs?

http://code.google.com/p/arducopter/wiki/Quad_ESC

This reply was deleted.

Neville Rodrigues liked Neville Rodrigues's profile

Santiago Perez liked Santiago Perez's profile

#xg { position:relative;top:120px; } #xn_bar { top:120px; }

Please check your browser settings or contact your system administrator.