Discussions

Replies

  • Hotwire November 28, 2014 at 6:11pm

    Fabulous thanks.

    MP could do with a reset PID defaults button.

    Cheers.

    • GadgetGeek > Hotwire November 28, 2014 at 6:43pm
      If you go in to terminal tab, connect. Then setup enter and reset enter or test enter reset. You can also try it by replacing reset with erase. Keep in mind this will erase everything. You will have to completely set up your apm like it was the first time. It's a piece of cake but the compass is a bit annoying to set up. Hope this helps you out buddy.
      • Hotwire > GadgetGeek November 30, 2014 at 4:18pm

        Hi

        Didn't want to go back there. Saving parameters is fine but you restore all of them too, if you run a restore.

        Backing up parameters each time I tune so I can do a quick recovery if the tune is unsatisfactory. It difficult to auto tune if the tuning starts to for off.

        Cheers.

      • GadgetGeek > GadgetGeek November 28, 2014 at 6:46pm
        But a reset PID button would be really nice! It would be a very useful addition to MP
  • GadgetGeek November 28, 2014 at 6:05pm
    This is the default pid settings. It would be nice if the was a calculator of some sort.

    image.jpg

  • GadgetGeek November 28, 2014 at 5:02pm
    I could send them to you if needed
    • GadgetGeek > GadgetGeek November 28, 2014 at 6:01pm
      I've done that myself a few times
    • Hotwire > GadgetGeek November 28, 2014 at 5:06pm

      That would be excellent. I should explain why. I used auto tune and some of the I values are nuts. It would be best to start from scratch but scratch requires removing all the other parmas too.

      So thank you and please do.

This reply was deleted.

Activity